Slide and Turn System SF 25 with frame

  • Height compensation profile allows a height adjustment of up to 22 mm
  • Height compensation profile with vertical flange
  • Height compensation profile with horizontal flange
  • Screw cap with cover clip
  • Completely stainless carriage system
  • Screwed glass; glass thickness 6, 8 or 10 mm possible
  • Turn knob
  • Carriage recess with covering flap
  • Optimal panel guidance without guide arm when opening and closing
  • Corner angle continuously adjustable for top track and height compensation profile

System Information

  • Framed sliding turn door system
  • Non-thermally insulated aluminum profiles with single pane glazing
  • Recessed or surface-mounted floor track (optional)
  • Either to open from inside or outside
  • Either with or without vertical frames
  • Lateral vertical frame profiles (optional)
  • Leveling profile can be installed to compensate height differences
  • Sound insulation value (Rw or weighted sound reduction) = STC 29 dB
  • Measurement of deflection class 4 according to DIN EN 12211/12210 (8, 10 mm glass)
  • Repeated pressure/wind suction class 4 according to DIN EN 12211/12210 (8 mm (1/4"), 10 mm (3/8") glass)
  • Safety test class 4 according to DIN EN 12211/12210 (8 mm (1/4"), 10 mm (3/8") glass)
  • All hardware concealed within profiles
  • Low-maintenance, non-corroding and failsafe hardware components
  • Locking and unlocking possible from inside and/or outside
  • Locking and unlocking via pull-bar or turn knob
  • Lockable latch (childproof) (optional)
  • Top-mounted, maintenance-free horizontal runner assemblies, each equipped with two rollers
  • Runner assemblies features three smooth-running needle bearings and two carbon fibre reinforced polyamide rollers respectively
  • All stainless steel metal components in runner assemblies
  • Low-noise, hard-wearing, heat and cold resistant running surfaces
  • Runner assemblies can cross any angle between 90° and 180°
  • Tongue and groove system between the leaves
  • Horizontal upper and lower brush seals fitted on inner and outer sides
  • Lower and upper brush seal attached to panel frame, not via guide track
  • 1/4”, 5/16”, 3/8” and 1/2” (6, 8, 10 and 12 mm) tempered single pane safety glass (ESG-H)
  • Panes are secured via concealed screw-fixing system in top and bottom door leaf profiles
  • Glazing can be replaced subsequently without difficulty
  • Leaves can be replaced subsequently without difficulty
  • Unassisted gravity drainage via an inclined sill construction
  • Integral water drainage channel on inside of floor track
  • End-caps seal both sides of floor track

You can choose from a large number of colours on the SUNFLEX colour wheel.