SF 55 H-S-W

thermally insulated aluminum system

The parking position of the sliding panels can be set individually in this thermally insulated aluminum system. A great variety of opening directions and panel distributions is feasible. As a result, the thermally insulated sliding wall can be utilized in virtually any area.

SF 55c H-S-W

thermally insulated aluminum system with wood cladding

In contrast to SF 50c H-S-W, this system consists of thermally insulated aluminum profiles. It also has a real wood cladding on the inside. The elegant and easy to use design of the related model remain the same.

Profile system

Horizontal sliding partition in thermally insulated aluminum profiles
Suspended design made up of individually sliding leaves
Rear-ventilated wooden cladding inside (SF55c) (optional)
The construction profile depth: 2 3/16” (55 mm) (SF55c = 2 30/32” (75 mm))
Opens to the inside, outside or pivoting
Opens by sliding to one side or both sides
Optionally with frame profiles on all sides
Height adjustment after installation possible

Hardware

All fittings hidden within profiles
Low-maintenance, non-corroding and failsafe hardware components
Leaf locking takes place via rods that engage approximately 22 mm in the floor
Locking and unlocking of leaves via actuating levers with anti-intruder catches
Leaves can additionally be fitted with profile cylinder locks
Design allows for a separately operated pass door panel with lever-operated multiple locking system, lock and profile cylinder

Runner system

Each element is hung from two runner assemblies that slide in a ceiling-mounted aluminum track
Low-noise, hard-wearing, heat and cold resistant running rollers
Runner assemblies can cross any angle between 90° and 180°

Sealing and ventilation

In the vertical panel joint rain and wind proofing ensured by EPDM seals at two sealing levels
Double brush seals with a flexible plastic base are fitted horizontally at bottom

Glazing