SF 30

aluminum system

The SF 30 aluminum system is distinguished by slim profile widths whose vertical frames set stylish accents. In addition, they can be installed quickly and without extensive conversion measures. The enhanced protection against noise, dirt and weather is a key aspect.

Technical Details (Example SF 25)
  • height compensation profile allows a height adjustment of up to 22 mm
  • Completely new, rustproof carriage system fitted with triple smooth-bearing needle bearings
  • Arched intake guide
  • Panel guide for flush floor rail
  • Infinitely adjustable corner piece for ceiling rail
  • Adjusted profile end cap for height adjustment profile and ceiling rail
  • Carriage outlet including new gap ventilation
  • Height adjustment profile with flange
  • Screw cover with clip-on screen
  • Reinforced plastic pivot bearing
  • New panel profile end caps for 6, 8 and 10 mm including glass slide block mount and cover clip fixture
  • Infinitely adjustable corner piece for height adjustment profile
  • Turn knob with integrated tensioning mechanism for rope extension
  • Up to 90° angling possible from the second panel in polygonal systems

Profile system

  • Framed sliding turn door system
  • Non-thermally insulated aluminum profiles with single pane glazing
  • Sound insulation value (Rw or weighted sound reduction) = STC 29 dB
  • Recessed or surface-mounted floor track (optional)
  • Either to open from inside or outside
  • Either with or without vertical frames
  • Lateral vertical frame profiles (optional)
  • Leveling profile can be installed to compensate height differences

Hardware

  • All hardware concealed within profiles
  • Low-maintenance, non-corroding and failsafe hardware components
  • Locking and unlocking possible from inside and/or outside
  • Locking and unlocking via pull-bar or turn knob
  • Lockable latch (childproof) (optional)

Runner system

  • Top-mounted, maintenance-free horizontal runner assemblies, each equipped with two rollers
  • Runner assemblies features three smooth-running needle bearings and two carbon fibre reinforced polyamide rollers respectively
  • All stainless steel metal components in runner assemblies
  • Low-noise, hard-wearing, heat and cold resistant running surfaces
  • Runner assemblies can cross any angle between 90° and 180°

Sealing and ventilation

  • Tongue and groove system between the leaves
  • Horizontal upper and lower brush seals fitted on inner and outer sides
  • Lower and upper brush seal attached to panel frame, not via guide track

Glazing

  • 1/4”, 5/16”, 3/8” and 15/32” (6, 8, 10 and 12 mm) tempered single pane safety glass (ESG-H)
  • Panes are secured via concealed screw-fixing system in top and bottom door leaf profiles
  • Glazing can be replaced subsequently without difficulty
  • Leaves can be replaced subsequently without difficulty

Drainage

  • Unassisted gravity drainage via an inclined sill construction
  • Integral water drainage channel on inside of floor track
  • End-caps seal both sides of floor track